Dc 6-30V 100W Sw3518 Charging Module Vehicle Desktop Charger Motherboard Multi-Protocol High-Power Quick Charging Module

Description: 100% new and high quality Output Interface: USB A and USB C Input voltage: DC 6-30V (24V DC power supply is recommended) Input and output type: only support output (battery power is not recommended) Protection mechanism: input over-voltage protection, input under-voltage protection, output over-current protection, output short-circuit protection, on-board integrated chip thermistor, equipped with fuses to ensure safe operation Support protocols: 1.Support PPS/PD3.0/PD2.0 2.Support QC4+/QC4/QC3.3/QC2.0 3.Support PE2.0/PE1.1 4. Support AFC/FCP/SFCP 5. Support VOOC (generation) maximum 22.5W Output power problem: the module because it is a buck module, the output should be greater than the input 1.2V. because 100w is PD protocol 20V5A, so only greater than 21.2V, can be full power output. 24V power supply is very cost-effective, so we recommend 24V power supply. Battery power problem: about battery power: the module can only output can not charge the battery, if only battery power can be, need to use 24v battery pack. If the car 12v, 12v can not be full power, pd protocol maximum 36w, only charge the phone is no problem. A port and C port output at the same time problem: single way A port and C port can output at the same time, but there is no fast charging, when output at the same time is assigned as 5V2A/5V2A. Package include: Module x1pcs Notes: Due to manual measurement , there may be 5mm deviation exist,hope you can understand. There are slight difference between the picture and the item caused by light brightness,hope you can understand. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.